When the robot starts to mopping task, the water content of the mop is relatively high. After 5 minutes of self-cleaning, it will reach a stable status, and then replenish water to maintain the overall water balance.
Please detect whether the water tank is out of water or not:
1.Selecting the mopping or mopping/sweeping mode
2.Tear off the mop pad, and only install the mop pad holder.
3.After 5 minutes of self-cleaning, look at the ground, check whether there are small water droplets on the ground.
4.Please tear down the rubber and reinstall the rubber water injection port
If there is water out of the water tank, we suggest you to set the“Frequency for the returning to self-clean”with the lower area to make the mop being wet enough.