1. Can I keep the vacuum always charge?
Yes, after full charge, the charging circuit will automatically disconnect.
2. Does it need to be charged after a long period of no use?
Yes. If you will not be using the product for an extended period, fully charge the battery, unplug the power adapter, and store the product in a cool, dry place. To prevent over-discharge, recharge the battery at least once every three months.
3. How Do I Empty the Dust Cup?
Press the dust cup bottom
Empty the dust cup
4. How often is the filter element changed? Can I clean it?
Cleaning: It's recommend to wipe the dust collecting bucket with a wrung out rag at least once a month. Clean the pre-filter once every 3 months and the cyclone system components once every 6 months.
Airing: the filter element assembly and sponge should be aired for about 24 hours before installation, so as to dry thoroughly.
5. How to clean the dust cup and filter system?
- Press the dust cup bottom cover release button, then empty the contents.
- Push the dust cup release switch in the direction indicated by the arrow, then gently
remove the dust cup from the vacuum. Remove the pre-filter first, then lift the handle of the cyclone assembly and turn it
counterclockwise until it stops, then pull to lift out the cyclone assembly.- Wipe the dust cup with a soft wet cloth. Pay attention to wringing out the cloth before
using. - Rinse the cyclone assembly and pre-filter until they are clean. After washing, air dry for
at least 24 hours.
6. How Do I Install or Remove the Battery?
The R10s Lite is equipped with a non-removable battery pack, and professional assistance is required.
7. What kind of garbage can a vacuum cleaner clean?
- Use indoor dry surfaces only.
- Do not use absorbent, gasoline and other flammable or explosive liquids. Do not inhale toxic solutions, such as chlorine bleach, ammonia, sewer cleaner or other liquids.
- Do not use vacuum cleaner to clean drywall ash, fireplace ash and ash, do not inhale smoke or combustion.
- Such as burning coals, cigarette butts or matches. Do not use a vacuum cleaner to clean sharp objects such as glass, nails, screws, coins, or it will cause damage to the vacuum cleaner.
8. How to clean the Illumination Multi Surface Brush?
Turn the brush with the edge upside down and push the release button to remove the brush from the slot.
- Use scissors to cut the hair and fibrous material on the roller . Wipe the notch and transparent cover with a rag or paper towel.
- When dirty, use clean water to rinse and roll until clean. Stand the roller brush upright while drying and allow it to dry thoroughly for at least 24 hours.